Product range
11 casting families,
192 catalogued references
Ductile iron covers, frames and gratings manufactured to BS EN 124, in load classes B125, C250, D400, F900. Every family carries a full dimensional schedule. Anything not listed can be made to your drawing.
Square and circular sealed access covers
Solid Top Covers
Ductile iron solid top covers and frames for sewer, storm water and utility chambers. Available single or double seal, with an optional G…
Two-piece covers for large clear openings
Double Triangular & Semi Circular
Two-piece triangular and semi-circular covers give a large clear opening while keeping each leaf within safe manual handling weight. The …
Gullies, channels, catch basins and surface boxes
Drainage Gratings
A full surface-water range: top entry and side entry gullies, continuous channel gratings and bearer bars, catch basin covers, curb inlet…
Multi-leaf cable chamber covers and frames
Telecom Covers
Long-span cable chamber covers built from two, four or six leaves in a single frame. Available solid top or recessed for block paving, as…
Filled covers that disappear into the finished surface
Recessed Covers
Recessed covers are filled on site with the surrounding paving, screed or asphalt so the chamber reads as part of the finished floor. Squ…
Round covers and frames including 860 mm heavy duty
Circular Covers
Round covers seat evenly under load and cannot fall into the shaft. The range runs from Ø750 access covers up to an Ø860 heavy duty unit …
Bolted watertight boxes and multi-leaf spans
Pull Box & Multipart Covers
Bolt-down pull box covers with a neoprene seal for watertight cable and utility chambers, plus multi-part solid top covers spanning openi…
Hinged access that opens to 100° and stays put
Hinge Covers & Gratings
Stainless steel hinge pin assemblies let a single operator open the cover safely and leave it standing at 100°, with a rubber seal on the…
Continuous slide-out runs for pumping stations
Trench Covers
Continuous recessed trench cover systems for pumping stations and service ducts. Covers slide out along the run rather than lifting clear…
Ductile iron core, stainless steel clad edge
Steel Cladding Recessed Covers
Recessed covers with a stainless steel clad frame and cover edge for architectural interiors, lobbies and wet areas where a ductile iron …
Multispan pumping station covers filled on site
Concrete Infill Covers
Slide-out pumping station covers filled with C45 concrete on site so the finished surface reads continuous. Frames are modular, so any pi…
Bespoke castings
Not in the schedule?
Pattern making is handled in house, so non-standard openings, badging and special alloys are routine work rather than an exception — from half a kilogram up to a tonne.